Dell PowerEdge VRTX - Manual (Page 543)

VLAN Commands 543
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\VLAN.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
console(config-if)# no switchport
switchport mode
Use the switchport mode Interface Configuration mode command to
configure the VLAN membership mode. Use the no form of this command to
restore the default configuration.
Syntax
switchport mode {access | trunk | general | private-vlan {promiscuous |
host} | customer}
no switchport mode
Parameters
• access—Specifies an untagged layer 2 VLAN port.
•
trunk—Specifies a trunking layer 2 VLAN port.
• general—Specifies a full 802-1q-supported VLAN port.
• customer—Specifies that the port is connected to customer equipment.
Used when the switch is in a provider network.
• private-vlan promiscuous—Private-VLAN promiscuous port.
• private-vlan host—Private-VLAN host port.
Default Configuration
Access mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When the port’s mode is changed, it receives the configuration corresponding
to the mode.
If the port mode is changed to access and the access VLAN does not exist,
then the port does not belong to any VLAN.