Dell PowerEdge VRTX - Manual (Page 554)

554 VLAN Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\VLAN.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
map protocol protocols-group
Use the map protocol protocols-group VLAN Configuration mode command
to map a protocol to a group of protocols. This protocol group can then be
used in switchport general map protocols-group vlan . Use the no form of this
command to delete a protocol from a group.
Syntax
map protocol protocol [ encapsulation-value ] protocols-group group
no map protocol protocol [ encapsulation ]
Parameters
• protocol —Specifies a 16-bit protocol number or one of the reserved names
listed in the User Guidelines. (range: 0x0600–0xFFFF)
• encapsulation-value —Specifies one of the following values: Ethernet,
rfc1042, llcOther.
• protocols-group group —Specifies the group number of the group of
protocols (range: 1–2147483647).
Default Configuration
The default encapsulation value is Ethernet.
Command Mode
VLAN Database Configuration mode
User Guidelines
Forwarding of packets based on their protocol requires setting up groups of
protocols and then mapping these groups to VLANs.
The value 0x8100 is not valid as the protocol number for Ethernet
encapsulation.
The following protocol names are reserved for Ethernet Encapsulation:
• ip
• arp
• ipv6