Dell POWEREDGE M1000E - Manual (Page 633)

Fabric OS Message Reference 557
53-1001767-01
SEC-1331
90
SEC-1331
Message
, [SEC-1331], ,, ERROR, , Attempt to
enable secure mode failed. Reason: .
Probable Cause Indicates the secModeEnable command failed on the fabric because default IP Filter policies are
not active on the switch, or an active transaction exists on IP Filter policies.
Recommended
Action
Verify the security event was planned. If the security event was planned, run the ipfilter --activate
default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter Policies.
Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active
transaction on IP Filter policies. Then retry the secModeEnable command.
Severity ERROR
SEC-1332
Message
, [SEC-1332], ,, ERROR, , Fabric wide
policy is conflicting as is present in the fabric wide policy and
5.3 or 5.2 switches present in the fabric.
Probable Cause Indicates the fabric-wide policy is conflicting.
Recommended
Action
Remove either the FCS from the fabric-wide policy, or remove 5.3 and 5.2 switches from the fabric,
or set the fabric-wide mode for FCS as Strict.
Severity ERROR
SEC-1333
Message
, [SEC-1333], ,, INFO, ,
command> command failed. There are VF enabled switches in fabric.
databases rejecting distribution> db(s) distribution is blocked.
Probable Cause Indicates an attempt to distribute PWD or IPFILTER databases from the fabric to a switch that is
VF-enabled.
Recommended
Action
If the databases need to be distributed, disable VF on all the switches that have VF enabled. If the
databases do not need to be distributed, no action is required.
Severity ERROR
SEC-3005
Message
, [SEC-3005], , AUDIT, INFO, , Event:
, Status: success, Info: Added member(s) to policy
.