Dell POWEREDGE M1000E - Manual (Page 737)

Fabric OS Message Reference 661
53-1001767-01
ZONE-1018
111
Probable Cause Indicates the fabric assist (FA) zoning configuration has more than one initiator. The probable
cause is incorrect entries in the FA zoning configuration.
Recommended
Action
Edit the zone database to ensure that only one initiator is set for each FA zone configuration.
Severity ERROR
ZONE-1018
Message
, [ZONE-1018], ,, ERROR, , Incorrect
zoning enforcement type() at port().
Probable Cause Indicates an incorrect zoning enforcement type was reported on the specified port. This is a
software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The
valid zone type values are:
• hard port zone (value = 1)
• hard wwn zone (value = 2)
• session based hard zoning (value = 3)
• FA zone (value = 5)
QuickLoop zones are not supported in Fabric OS v4.x and above.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
ZONE-1019
Message
, [ZONE-1019], ,, ERROR, , Transaction
Commit failed. Reason code () - \"
string>\"
Probable Cause Indicates the reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit
changes to the configuration database within a fabric.
Recommended
Action
Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Make sure your changes to the zone database are not overwriting the work of another admin.
Run the cfgTransShow command to find out if there is any outstanding transaction running on the
local switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR