Dell POWEREDGE M1000E - Manual (Page 154)

78 Fabric OS Message Reference
53-1001767-01
BM-1004
10
Recommended
Action
Use the slotPowerOff and slotPowerOn commands or reseat the affected blade.
Severity WARNING
BM-1004
Message
, [BM-1004], ,, INFO, , Blade firmware
on slot is not consistent with system firmware
firmware>. Auto-leveling blade firmware to match system firmware.
Probable Cause Indicates the policy of the specified blade is to auto-level the blade firmware to the system
firmware. The reason for the inconsistency may be due to either of the following reasons:
• Blade firmware was detected to be different from the control processor (CP) firmware due to a
firmware upgrade.
• The blade was just inserted and had a different version of the firmware loaded.
Recommended
Action
No action is required. The blade will automatically download the updated firmware.
Severity INFO
BM-1005
Message
, [BM-1005], ,, WARNING, ,
Firmwaredownload timed-out for blade in slot . Faulting blade.
Probable Cause Indicates the firmwareDownload command failed for the blade in the specified slot.
Recommended
Action
Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. On the Brocade
7500 or 7600, switch off and switch on all primary power to power-cycle the unit.
Severity WARNING
BM-1006
Message
, [BM-1006], ,, INFO, , Blade is not
configured. Persistently disabling all ports for blade in slot .
Probable Cause Indicates the policy of the specified blade is set to persistently disable all ports the first time the
blade is detected. The message indicates either of the following:
• The blade was detected in this slot for the first time.
• The blade was configured under a different mode.
Recommended
Action
Configure the blade so that it will persistently enable the ports.
Severity INFO