Dell POWEREDGE M1000E - Manual (Page 119)

Fabric OS Message Reference 43
53-1001767-01
AUTH-1017
4
Probable Cause This may relate to an internal failure.
Recommended
Action
Copy the message, collect switch information using the supportShow command, and contact your
switch service provider.
Severity ERROR
AUTH-1017
Message
, [AUTH-1017], ,, ERROR, , Invalid value
to start authentication request: port , operation code
code>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1018
Message
, [AUTH-1018], ,, ERROR, , Invalid value
to check protocol type: port .
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1020
Message
, [AUTH-1020], ,, INFO, , Failed to
create timer for authentication: port .
Probable Cause Indicates that an authentication message's timer was not created.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.