Fcr-1083, Fcr-1084, Fcr-1085 – Dell POWEREDGE M1000E User Manual
Page 312: Fcr-1086

236
Fabric OS Message Reference
53-1001767-01
FCR-1083
34
FCR-1083
Message
message is rejected by the domain
Probable Cause
Indicates that during the Coordinated HotCode protocol, a switch in the fabric has rejected the
pause message which prevented the protocol from completing. Any data traffic disruption observed
during the firmware download may have been due to the rejected resume message.
Recommended
Action
No action is required.
Severity
WARNING
FCR-1084
Message
retry count is exhausted for the domain
Probable Cause
Indicates that during the Coordinated HotCode protocol, a switch in the fabric did not accept the
resume message which prevented the protocol from completing. Any data traffic disruption
observed during the firmware download may have been due to this issue.
Recommended
Action
No action is required.
Severity
WARNING
FCR-1085
Message
as remote CP does not support FCR based matrix.
Probable Cause
Indicates that the remote control processor (CP) has earlier firmware, which does not support the
FCR- based matrix while the local CP has the feature enabled. This is causing the loss of the
high-availability (HA) synchronization.
Recommended
Action
Disable FCR-based matrix or upgrade the remote CP.
Severity
ERROR
FCR-1086
Message
as remote CP does not support Condor2 based EX_ports.
Probable Cause
Indicates that the remote control processor (CP) has older firmware, which does not support
Condor-based EX_ port. This is causing the loss of the high-availability (HA) synchronization.