Dell POWEREDGE M1000E - Manual (Page 137)

Fabric OS Message Reference 61
53-1001767-01
BL-1007
7
BL-1007
Message
, [BL-1007], ,, WARNING, , blade #
number>: blade state is inconsistent with EM. bl_cflags 0x,
slot_on , slot_off , faulty , status
.
Probable Cause Indicates that a failover occurred while a blade was initializing on the previously active control
processor (CP).
Recommended
Action
No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive
operation and can stop I/O traffic, you might have to stop and restart the traffic during this process.
Severity WARNING
BL-1008
Message
, [BL-1008], , FFDC, CRITICAL, , Slot
control-plane failure. Expected value: 0x, Actual: 0x
2>.
Probable Cause Indicates that the blade has experienced a hardware failure or was removed without following the
recommended removal procedure.
Recommended
Action
Make sure that the blade is seated correctly.
If the blade is seated correctly, restart or power cycle the blade.
Run the systemVerification command to verify that the blade does not have hardware problems. To
run this command root access is required. Run the diagPost command to ensure that Power-On
Self-Test (POST) is enabled. Refer to the Fabric OS Command Reference for more information on
these commands.
If the message persists, replace the blade.
Severity CRITICAL
BL-1009
Message
, [BL-1009], , FFDC, CRITICAL, , Blade
in slot timed out initializing the chips.
Probable Cause Indicates that the blade has failed to initialize the application-specific integrated circuit (ASIC)
chips.
Recommended
Action
Make sure that the blade is seated correctly.
If the blade is seated correctly, reboot or power cycle the blade.
Run the systemVerification command to verify that the blade does not have hardware problems. To
run this command root access is required. Run the diagPost command to ensure that Power-On
Self-Test (POST) is enabled. Refer to the Fabric OS Command Reference for more information on
these commands.