Dell POWEREDGE M1000E - Manual (Page 624)

548 Fabric OS Message Reference
53-1001767-01
SEC-1253
90
Probable Cause Indicates the security database conversion failed because of invalid values. The reason is specified
in the text message variable and a faulty value is printed in the value variable.
Recommended
Action
Retry the failed security command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
SEC-1253
Message
, [SEC-1253], ,, ERROR, , Bad DCC
interface state during , state=.
Probable Cause Indicates an internal error has caused the device connection control (DCC) policy update to fail in
the provision, commit, or cancel phases.
Recommended
Action
Retry the failed security command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
SEC-1300
Message
, [SEC-1300], ,, INFO, , This switch is
in VcEncode mode. Security is not supported.
Probable Cause Indicates the switch is set up with VC-encoded mode.
Recommended
Action
Turn off VC-encoded mode before enabling security.
Severity INFO
SEC-1301
Message
, [SEC-1301], ,, INFO, , This switch is
in interop mode. Security is not supported.
Probable Cause Indicates the switch is interop-mode enabled.
Recommended
Action
Disable interop-mode using the interopMode command before enabling the Secure Fabric OS
feature.
Severity INFO