Dell POWEREDGE M1000E - Manual (Page 524)

448 Fabric OS Message Reference
53-1001767-01
NS-1004
72
Reduce the local device count to follow the capability of the lowest version of firmware.
Severity INFO
NS-1004
Message
, [NS-1004], ,, INFO, , Number of local
devices , exceeds the standby can support
device count that standby can support>, can't sync.
Probable Cause Indicates the name server on the standby CP has lower supported capability than the active CP
because of different firmware versions running on the active and standby CPs. This means that the
active and standby CPs are out of sync. Any execution of the haFailover or firmwareDownload
commands will be disruptive.
Recommended
Action
To avoid disruption of traffic in the event of an unplanned failover, schedule a firmwareDownload
so that the active and standby CPs have the same firmware version.
Reduce the local device count to follow the capability of the lowest version of firmware.
Severity INFO
NS-1005
Message
, [NS-1005], ,, WARNING, , Zone size of
has over the supporting limit of for the
remote switch domain ID .
Probable Cause Indicates the effective zone size has exceeded the limit that a remote switch can support. The
oversized portion will be truncated.
Recommended
Action
Reduce the zone size to 1024 or smaller, or upgrade the software of the remote switch to support
2048 zones.
Severity WARNING
NS-1006
Message
, [NS-1006], ,, WARNING, , Duplicated
WWN was detected with PID and .
Probable Cause Indicates that an existing device has the same WWN as a new device that has come online.
Recommended
Action
The switch will process the new PID and leave the existing PID intact. Subsequent switch
operations will clean up the obsolete PID. However, administrators could check and remove devices
with a duplicated WWN.
Severity WARNING