Auth-1040, Auth-1041, Auth-1042 – Dell POWEREDGE M1000E User Manual
Page 126

50
Fabric OS Message Reference
53-1001767-01
AUTH-1040
4
Severity
ERROR
AUTH-1040
Message
authentication on port
to OFF.
Probable Cause
Indicates that the local switch has rejected the authentication because the switch policy is turned
off. If the neighboring switch has a strict (ON) switch policy, the light will go off due to conflicting
configuration settings. Otherwise E_Port will form without authentication.
Recommended
Action
If there is no light on the port, correct the switch policy configuration on either of the switches using
the authUtil command, and then enable the port on the neighboring switch using the portEnable
command. If the E_Port formed, no action is required.
Severity
INFO
AUTH-1041
Message
number> has been disabled, because an authentication-reject was received with code ' Probable Cause The specified port had been disabled, because it received an authentication-reject response from Recommended Action Check the connection port for a possible security attack. Check the shared secrets using the secAuthSecret command and reinitialize authentication using If the message persists, run the supportFtp command (as needed) to set up automatic FTP Severity ERROR AUTH-1042 Message number> has been disabled, because authentication failed with code ' String>' and explanation ' Probable Cause The specified port has been disabled, because the connecting switch/device failed to authenticate. Recommended Action Check the connection port for a possible security attack. Check the shared secrets using the secAuthSecret command and reinitialize authentication using
the connected switch/device. The error might indicate that an invalid entity attempted to connect to
the switch.
the portDisable and portEnable commands.
transfers; then run the supportSave command and contact your switch service provider.
The error might indicate that an invalid entity attempted to connect to the switch.
the portDisable and portEnable commands.