Dell POWEREDGE M1000E - Manual (Page 632)

556 Fabric OS Message Reference
53-1001767-01
SEC-1328
90
Probable Cause Indicates the policy is conflicting with the domain.
Recommended
Action
No action is required. The domain is denied by disallowing all its E_ports connected to the fabric. If
the domain should be allowed to merge with the fabric, then resolve the issue by making the
conflicting policies the same.
Severity WARNING
SEC-1328
Message
, [SEC-1328], ,, ERROR, , Attempt to
enable secure mode failed. Reason: .
Probable Cause Indicates the secModeEnable command failed on the fabric because Authentication Policy is
enabled on the switch.
Recommended
Action
Verify the security event was planned. If the security event was planned, run the authUtil --policy
passive command to disable the Authentication Policy and retry the secModeEnable command.
Severity ERROR
SEC-1329
Message
, [SEC-1329], ,, ERROR, , IPFilter
enforcement: Failed to enforce ipfilter policy of type because of
.
Probable Cause Indicates the IP filter policy enforcement failed due to internal system failure.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1330
Message
, [SEC-1330], ,, ERROR, ,
command> command failed - db(s) are
coming from a non-Primary switch.
Probable Cause Indicates an attempt was made to distribute databases either from a backup fabric configuration
server (FCS) switch or from a non-FCS switch.
Recommended
Action
Verify the distribution is initiated by the primary FCS switch. Use the secPolicyShow command to
verify and correct the configuration if necessary.
Severity ERROR