Em-1016, Em-1017, Em-1018 – Dell POWEREDGE M1000E User Manual
Page 230: Em-1019

154
Fabric OS Message Reference
53-1001767-01
EM-1016
22
Severity
WARNING
EM-1016
Message
failed (
).
Probable Cause
Indicates that a problem was discovered when performing consistency checks during a cold boot.
Recommended
Action
Monitor the switch.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
EM-1017
Message
WWN change detected. Cold reboot required.
Probable Cause
Indicates that a user did not commit a changed world wide name (WWN) value prior to executing a
reboot, power cycle, or firmwareDownload operation.
Recommended
Action
Change and commit the new WWN value.
Severity
WARNING
EM-1018
Message
blade in slot fault descriptor>/ Probable Cause Indicates that there was a failure to read the chassis type from the system. Recommended Action Verify that the control processor (CP) blade is operational and is properly seated in its slot. Severity CRITICAL EM-1019 Message chassis configuration option ( ) is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync.