Eswch system messages, Chapter 24, Esw-1001 – Dell POWEREDGE M1000E User Manual
Page 245: Esw-1002, Esw-1003, Chapter

Fabric OS Message Reference
169
53-1001767-01
Chapter
24
ESWCH System Messages
ESW-1001
Message
in ready state - Switch enable failed switch status= 0x
0x
Probable Cause
Indicates that the switch enable has failed.
Recommended
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity
ERROR
ESW-1002
Message
violation: Unauthorized device number>. Probable Cause Indicates that the device is not present in the authorized profile list. Recommended Action Verify that the device is authorized to log in to the switch. If the device is authorized, first run the Severity INFO ESW-1003 Message but Not Ready during recovery, disabling slot = Probable Cause Indicates that the slot state has been detected as inconsistent during failover or recovery. Recommended Action On a Brocade 8000 switch, restart or power cycle the switch. Severity ERROR
secPolicyDump command to verify whether the specified device world wide name (WWN) is listed. If
it is not listed, run the secPolicyAdd command to add this device to an existing policy.