Fabr-1030, Fabr-1031, Fabr-1032 – Dell POWEREDGE M1000E User Manual
Page 259
Fabric OS Message Reference
183
53-1001767-01
FABR-1030
26
•
VC_RDY mode: Virtual-channel flow control mode. This is a proprietary protocol.
•
R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol,
that uses R_RDY primitive for flow control.
•
DUAL_CR mode: Dual-credit flow control mode. In both of the previous modes, the buffer
credits are fixed, based on the port configuration information. In this mode, the buffer credits
are negotiated as part of exchange link parameter (ELP) exchange. This mode also uses the
R_RDY primitive for flow control.
Recommended
Action
No action is required.
Severity
INFO
FABR-1030
Message
Probable Cause
Indicates that the domain ID has changed.
Recommended
Action
No action is required.
Severity
INFO
FABR-1031
Message
Maximum number of retries sending ILS from port
exceeded.
Probable Cause
Indicates the fabric exhausted the maximum number of retries sending internal link service (ILS) to
the iswitchd demon on the specified E_Port.
Recommended
Action
Run the top command to see if iswitchd is extremely busy or if another process is using excessive
CPU resources.
Severity
WARNING
FABR-1032
Message
switch with domain ID
FOS version v2.x has joined the fabric.
Probable Cause
Indicates that a switch with an unsupported Fabric OS version 2.x has joined the fabric.
Recommended
Action
Remove the switch with the unsupported Fabric OS version 2.x from the fabric.