Sulb-1025, Sulb-1026, Sulb-1030 – Dell POWEREDGE M1000E User Manual
Page 694: Sulb-1031

618
Fabric OS Message Reference
53-1001767-01
SULB-1025
97
SULB-1025
Message
in slot
Probable Cause
Indicates new firmware has been downloaded to the specified AP blade and that the AP blade will
reboot to activate it.
Recommended
Action
Wait for the blade to reboot.
Severity
WARNING
SULB-1026
Message
Firmware commit operation started on the blade in slot
Probable Cause
Indicates the firmwareCommit has started on the specified blade. The operation may be a normal
part of firmwareDownload, or it may have started to repair the secondary partition of the blade if
the secondary partition is corrupted.
Recommended
Action
No action is required.
Severity
WARNING
SULB-1030
Message
during relocating the internal firmware image.
Probable Cause
Indicates there may be an error caused by an unexpected disruption of the firmwareDownload
command, for example, by powering the switch off and on in the middle of a firmwareDownload.
The error may also be caused by persistent storage hardware failure or by a software error.
Recommended
Action
The firmwareDownload command will continue after the switch has rebooted. Run the
firmwareDownloadStatus command to monitor progress. If the problem persists, contact your
switch service provider.
Severity
WARNING
SULB-1031
Message
switch is relocating an internal firmware image.
Probable Cause
Indicates the switch has rebooted with the new firmware and is relocating the AP firmware.