Dell POWEREDGE M1000E - Manual (Page 227)

Fabric OS Message Reference 151
53-1001767-01
EM-1006
22
EM-1006
Message
, [EM-1006], , FFDC, CRITICAL, ,
Id> has faulted. Sensors below minimum limits.
Probable Cause Indicates that the sensors show the voltage is below minimum limits. The switch or specified blade
is being shut down for environmental reasons; the voltage is too low.
Recommended
Action
If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the
blade.
If this problem occurs on a switch, it usually indicates a hardware problem on the main board;
replace the switch.
Severity CRITICAL
EM-1007
Message
, [EM-1007], , FFDC, CRITICAL, ,
Id> is being reset. Sensors has exceeded max limits.
Probable Cause Indicates that the voltage on a switch has exceeded environmental limits. A reset is sent to the
faulty slot or the switch for nonbladed switches.
Recommended
Action
There is most likely a voltage hardware problem on the blade or motherboard of the switch.
For the Brocade DCX, 24000 and 48000, replace the blade field-replaceable unit (FRU).
For the Brocade 3900 replace the motherboard FRU.
For the Brocade 200E, 3016, 3250, 3850, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000,
7500, AP7600, replace the switch.
Severity CRITICAL
EM-1008
Message
, [EM-1008], , FFDC, CRITICAL, , Unit in
with ID is faulted, it is incompatible with the
configuration.
Probable Cause Indicates that a blade inserted in the specified slot or the switch (for nonbladed switches) is not
compatible with either the platform configuration or the logical switch configuration. The blade is
faulted.
Recommended
Action
If the blade is not compatible, replace the blade and ensure the replacement blade is compatible
with your control processor (CP) type. If the incompatibility is with the logical switch configuration,
change the configuration with the lscfg command to be consistent with the blade type or remove
the blade.
Severity CRITICAL