Dell POWEREDGE M1000E - Manual (Page 306)

230 Fabric OS Message Reference
53-1001767-01
FCR-1063
34
Probable Cause Indicates that the maximum number of supported EX_ports or VEX_ports was exceeded. To enable
the specified port, disable any other operational port then re-enable the port.
Recommended
Action
No action is required.
Severity INFO
FCR-1063
Message
, [FCR-1063], ,, INFO, , Fabric
ID> for switch with domain ID: mismatch with local fabric ID
fabric ID>.
Probable Cause Indicates that the fabric ID of the switch does not match the local switch.
Recommended
Action
Run the switchShow command to display the fabric ID. Change the fabric ID to match on both ends
by modifying either the local or remote host using the fcrConfigure command.
Severity INFO
FCR-1064
Message
, [FCR-1064], ,, ERROR, , Fabric ID of
backbone FC-Routers mismatch or overlap.
Probable Cause Indicates that either (1) a backbone fabric split and both are connected to common edge fabrics, or
(2) the fabric IDs of two backbone fabrics connected to an edge fabric are the same.
Recommended
Action
If the backbone fabric split, merge the fabrics.
If two (or more) backbone fabrics have the same IDs, make the fabric IDs unique using fcrConfigure
command.
Severity ERROR
FCR-1065
Message
, [FCR-1065], ,, ERROR, , Fabric on port
was assigned two different fabric IDs.
Probable Cause Indicates that another port on the switch is connected to the same edge fabric with a different
fabric ID assignment.
Recommended
Action
Change the port fabric ID to same value as the other ports connected to the edge fabric using the
portCfgExport or portCfgVexport commands.
Severity ERROR