Sec-1056, Sec-1057, Sec-1059 – Dell POWEREDGE M1000E User Manual
Page 591: Sec-1062

Fabric OS Message Reference
515
53-1001767-01
SEC-1056
90
SEC-1056
Message
position
Probable Cause
Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configurations server (FCS) is distributing the security database to
the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1057
Message
Both positions are the same.
Probable Cause
Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1059
Message
Probable Cause
Indicates the operation failed when writing to flash.
Recommended
Action
Run the supportFtp - e command to FTP files from the switch and remove them from the flash.
Severity
ERROR
SEC-1062
Message
of Domains in Domain List.