Dell POWEREDGE M1000E - Manual (Page 426)

350 Fabric OS Message Reference
53-1001767-01
FW-1516
42
Probable Cause Indicates that the number of signal losses that the port experiences has changed and crossed
lower threshold boundary to a value within the acceptable range. Loss of signal generally indicates
a physical problem.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation. Frequent loss of signal generally indicates a physical problem. Check both
ends of your cable connection. Verify that the cable and small form-factor pluggables (SFPs) are not
faulty.
Severity INFO
FW-1516
Message
, [FW-1516], ,, INFO, , ,
, has dropped below upper threshold boundary to in between(High=
value>, Low=). Current value is .
Probable Cause Indicates that the number of signal losses that the port experiences has changed and dropped
below upper threshold boundary to a value within the acceptable range. Loss of signal generally
indicates a physical problem.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation. Frequent loss of signal generally indicates a physical problem. Check both
ends of your cable connection. Verify that the cable and small form-factor pluggables (SFPs) are not
faulty.
Severity INFO
FW-1517
Message
, [FW-1517], ,, INFO, , ,
, has crossed lower threshold boundary to in between(High=,
Low=). Current value is .
Probable Cause Indicates that the number of protocol errors that the port experiences has changed and crossed
lower threshold boundary to a value within the acceptable range. Occasional protocol errors occur
due to software glitches. Persistent protocol errors occur due to hardware problems.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1518
Message
, [FW-1518], ,, INFO, , ,
, has dropped below upper threshold boundary to in between(High=
value>, Low=). Current value is .