Fcr-1073, Fcr-1074, Fcr-1075 – Dell POWEREDGE M1000E User Manual
Page 309

Fabric OS Message Reference
233
53-1001767-01
FCR-1073
34
FCR-1073
Message
domain ID
supported.
Probable Cause
Indicates that an earlier version of the switch in the backbone or edge that supports a different
limit of logical storage area network (LSAN) zones was detected.
Recommended
Action
Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find the
lowest supported LSAN zone limits. Ensure that total number of LSAN zones in the Meta-SAN are
within the lowest supported limit of LSAN zones.
Severity
INFO
FCR-1074
Message
as remote CP supports only
Probable Cause
Indicates that the remote control processor (CP) has older firmware, which only supports a lower
number of logical storage area network (LSAN) zones. This is causing the loss of the
high-availability (HA) sync.
Recommended
Action
Keep the number of LSAN Zones to the lower limit of the two CPs or upgrade the remote CP.
Severity
ERROR
FCR-1075
Message
configuration is larger than
connected to port
Probable Cause
Indicates that the zone name configuration size created in the connected fabric exceeds the
maximum supported by the FC Router. This size is equal to the total number of characters used by
all the zone names in the edge fabric zoning database.
The limit includes both logical storage area network (LSAN) and Non-LSAN zone names defined in
zoning name database of the edge fabric.
Recommended
Action
Limit the zone configuration size in the edge fabric connected to this port by either reducing
number of zones or changing the zone names to smaller names.
Severity
ERROR