Dell POWEREDGE M1000E - Manual (Page 746)

670 Fabric OS Message Reference
53-1001767-01
ZONE-1053
111
ZONE-1053
Message
, [ZONE-1053], ,, INFO, , The Default
Zone state is set to Disabled.
Probable Cause Indicates the Interop Default Zone attribute state is disabled.
Recommended
Action
Verify if the Interop Default Zone attribute state change was done on purpose.
Severity INFO
ZONE-1054
Message
, [ZONE-1054], ,, WARNING, , DEFZONE
ALLACCESS set with Frame Redirection zones.
Probable Cause Indicates the DEFZONE allaccess mode will not grant all access behavior when frame redirection
zones are defined.
Recommended
Action
Remove frame redirection zones or set the defzone command to noaccess mode.
Severity WARNING
ZONE-1055
Message
, [ZONE-1055], ,, WARNING, , McDATA
default zone enabled with Frame Redirection zones.
Probable Cause Indicates that frame redirection will not function properly with McDATA default zoning.
Recommended
Action
Remove frame redirection zones or disable McDATA default zoning.
Severity WARNING
ZONE-1056
Message
, [ZONE-1056], ,, WARNING, ,
Non-ETIZ-Capable Switch (dom ) in fabric w/ETIZ Configured.
Probable Cause Indicates the config Save/Enable/Disable operations will not work with pre-6.4.0 FOS switch in IM2
fabric when ETIZ Zones are configured.
Recommended
Action
Remove pre-6.4.0 FOS switch from fabric or delete Enhanced TI Zone(s).
Severity WARNING