Dell POWEREDGE M1000E - Manual (Page 598)

522 Fabric OS Message Reference
53-1001767-01
SEC-1089
90
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1089
Message
, [SEC-1089], ,, ERROR, , Policy name
was not found.
Probable Cause Indicates the security policy name in the secPolicyAdd command does not exist.
Recommended
Action
Create the appropriate security policy first, then use its name in the secPolicyAdd command to add
new members.
Severity ERROR
SEC-1090
Message
, [SEC-1090], ,, ERROR, , SCC list
contains FCS member. Please remove member from the FCS policy first.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1091
Message
, [SEC-1091], ,, ERROR, , No policy to
remove.
Probable Cause Indicates the specified policy member does not exist or the policy itself does not exist.
Recommended
Action
Verify that the security policy name or member ID is correct.
Severity ERROR