Swch system messages, Chapter 98, Swch-1001 – Dell POWEREDGE M1000E User Manual
Page 699: Swch-1002, Swch-1003, Chapter

Fabric OS Message Reference
623
53-1001767-01
Chapter
98
SWCH System Messages
SWCH-1001
Message
in ready state - Switch enable failed switch status= 0x
0x
Probable Cause
Indicates the switch is enabled before it is ready.
Recommended
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity
ERROR
SWCH-1002
Message
violation: Unauthorized device number>. Probable Cause Indicates the device is not present in the authorized profile list. Recommended Action Verify the device is authorized to log in to the switch. If the device is authorized, run the Severity INFO SWCH-1003 Message but Not Ready during recovery, disabling slot = Probable Cause Indicates the slot state has been detected as inconsistent during failover or recovery. Recommended Action On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn On a Brocade 7500 or AP7600 switch, reboot or power cycle the switch. Severity ERROR
secPolicyDump command to verify whether the specified device world wide name (WWN) is listed. If
it is not listed, run the secPolicyAdd command to add this device to an existing policy.
command.