Sec-1029, Sec-1030, Sec-1031 – Dell POWEREDGE M1000E User Manual
Page 584: Sec-1032

508
Fabric OS Message Reference
53-1001767-01
SEC-1029
90
SEC-1029
Message
character in
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can occur only
when the primary fabric configuration server (FCS) distributes the security database to the other
switches in the fabric, then local validation finds the error in the security database. This is a rare
occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1030
Message
the name invalid.
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can occur only
when the primary fabric configuration server (FCS) distributes the security database to the other
switches in the fabric, then local validation finds the error in the security database. This is a rare
occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1031
Message
security policy DB cannot be supported by standby. CPs will go out of sync.
Probable Cause
Indicates the security database size is not supported by the standby control processor (CP).
Recommended
Action
Reduce the security policy size by deleting entries within a policy or by deleting some policies.
Severity
WARNING
SEC-1032
Message
is not allowed.