Dell POWEREDGE M1000E - Manual (Page 702)

626 Fabric OS Message Reference
53-1001767-01
SWCH-1011
98
Severity WARNING
SWCH-1011
Message
, [SWCH-1011], ,, WARNING, , HA state
out of sync: Standby CP (ver = ) does not support Trunk Area
functionality. (active ver = , Trunk Area enabled on switch =
<'1' if Trunk Area ports exist; Otherwise '0'>).
Probable Cause Indicates the standby control processor (CP) does not support Trunk Area functionality, but the
switch has some ports with Trunk Area enabled.
Recommended
Action
Load a firmware version on standby that supports Trunk Area functionality, using the
firmwareDownload command.
Severity WARNING
SWCH-1012
Message
, [SWCH-1012], ,, INFO, , Trunk Area
() has been enabled for one or more ports).
Probable Cause Indicates that a Trunk Area has been enabled for one or more ports and the configuration file has
been updated.
Recommended
Action
No action is required.
Severity INFO
SWCH-1013
Message
, [SWCH-1013], ,, INFO, , Trunk Area has
been disabled for one or more ports.
Probable Cause Indicates that a Trunk Area assignment has been disabled for one or more ports and the
configuration file has been updated.
Recommended
Action
No action is required.
Severity INFO
SWCH-1014
Message
, [SWCH-1014], ,, INFO, , All Trunk
Areas have been disabled.
Probable Cause Indicates that all Trunk Areas have been disabled and the configuration file has been updated.