Dell POWEREDGE M1000E - Manual (Page 268)

192 Fabric OS Message Reference
53-1001767-01
FABS-1012
27
Recommended
Action
Reboot or power-cycle the CP or system.
If the message persists, run the firmwareDownload command to update the firmware.
Severity ERROR
FABS-1012
Message
, [FABS-1012], ,, ERROR, ,
name>[]:FRU state transition failed. Current state 0x
state of FRU> Requested state 0x err 0x
Probable Cause A FRU could not be transitioned to the requested state. This is usually an internal Fabric OS
problem.
Recommended
Action
Reboot or power-cycle the CP or system.
If the message persists, run the firmwareDownload command to update the firmware.
Severity ERROR
FABS-1013
Message
, [FABS-1013], ,, ERROR, ,
name>[]:Unknown blade type 0x
Probable Cause Indicates an unrecognized type of blade has been discovered in the system.
This may be caused by an incorrect FRU header, inability to read the FRU header, or the blade may
not be supported by this platform or Fabric OS version.
Recommended
Action
Verify that the blade is valid for use in this system and this version of Fabric OS.
Try reseating the blade.
If this is a valid blade and reseating does not fix the problem, then replace the blade.
Severity ERROR
FABS-1014
Message
, [FABS-1014], ,, ERROR, ,
name>[]:Unknown FRU type 0x
Probable Cause Indicates an unrecognized type of FRU has been discovered in the system.
This may be caused by an incorrect FRU header, inability to read the FRU header, or the FRU may
not be supported by this platform or Fabric OS version.
Recommended
Action
Verify that the FRU is valid for use in this system and this version of Fabric OS.
Try reseating the FRU.
If this is a valid FRU and reseating does not help, then replace the FRU.