Dell POWEREDGE M1000E - Manual (Page 535)

Fabric OS Message Reference 459
53-1001767-01
Chapter
75
PDM System Messages
PDM-1001
Message
, [PDM-1001], ,, WARNING, , Failed to
parse the pdm config.
Probable Cause Indicates the parity data manager (PDM) process could not parse the configuration file. This might
be caused by a missing configuration file during the installation.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
PDM-1002
Message
, [PDM-1002], ,, WARNING, , ipcInit
failed.
Probable Cause Indicates the parity data manager (PDM) process could not initialize the inter-process
communication (IPC) mechanism.
Recommended
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
PDM-1003
Message
, [PDM-1003], ,, WARNING, , pdm [-d] -S
-s .
Probable Cause Indicates a syntax error occurred when trying to launch the parity data manager (PDM) process.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING