Dell POWEREDGE M1000E - Manual (Page 147)

Fabric OS Message Reference 71
53-1001767-01
BL-1037
7
BL-1037
Message
, [BL-1037], ,, CRITICAL, , Faulting
chip in slot = , miniS = , port = due to
BE/BI port fault.
Probable Cause Indicates a fault on the chip and that all ports on the chip have been disabled.
Recommended
Action
No action is required.
Severity CRITICAL
BL-1038
Message
, [BL-1038], ,, CRITICAL, , Inconsistent
FPGA image version detected, please restart the switch for recovery.
Probable Cause Indicates that the FPGA image version is incompatible with the software version.
Recommended
Action
Restart the switch. If the message persists, replace the switch.
Severity CRITICAL
BL-1039
Message
, [BL-1039], ,, CRITICAL, , Inconsistent
FPGA image version detected, faulting the blade in slot .
Probable Cause Indicates that the FPGA image version is incompatible with the software version.
Recommended
Action
Power cycle the blade. If the message persists, replace the blade.
Severity CRITICAL
BL-1041
Message
, [BL-1041], ,, CRITICAL, , Dynamic area
mode is enabled on default switch, Faulting the blade w/ ID
that has the mini SFP+ that does not support it> in slot as it does
not support this mode.
Probable Cause Indicates that the blade does not support dynamic area mode on default switch.
Recommended
Action
Turn off the dynamic area mode through Configure CLI.
Severity CRITICAL