Dell POWEREDGE M1000E - Manual (Page 118)

42 Fabric OS Message Reference
53-1001767-01
AUTH-1012
4
AUTH-1012
Message
, [AUTH-1012], ,, WARNING, ,
Authentication is rejected: port explain
reason .
Probable Cause Indicates that an authentication is rejected because the remote entity does not support
authentication.
Recommended
Action
Make sure the entity at the other end of the link supports authentication.
Severity WARNING
AUTH-1013
Message
, [AUTH-1013], ,, WARNING, , Can not
perform authentication request message: port , message code
code>.
Probable Cause Indicates that the system is running low on resources when receiving an authentication request.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
AUTH-1014
Message
, [AUTH-1014], , FFDC, ERROR, , Invalid
port value to : port .
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1016
Message
, [AUTH-1016], , FFDC, ERROR, , Invalid
value to start HBA authentication port: , .