Dell POWEREDGE M1000E - Manual (Page 251)

Fabric OS Message Reference 175
53-1001767-01
Chapter
26
FABR System Messages
FABR-1001
Message
, [FABR-1001], ,, WARNING, , port
number>, .
Probable Cause Indicates that the specified switch port is isolated because of a segmentation resulting from
mismatched configuration parameters.
Recommended
Action
Based on the segmentation reason displayed within the message, look for a possible mismatch of
relevant configuration parameters in the switches at both ends of the link.
Run the configure command to modify the appropriate switch parameters on both the local and
remote switch.
Severity WARNING
FABR-1002
Message
, [FABR-1002], ,, WARNING, , fabGaid: no
free multicast alias IDs.
Probable Cause Indicates that the fabric does not have any available multicast alias IDs to assign to the alias
server.
Recommended
Action
Verify alias IDs using the fabricShow command on the principal switch.
Severity WARNING
FABR-1003
Message
, [FABR-1003], ,, WARNING, , port
number>: ILS bad size , wanted .
Probable Cause Indicates that an internal link service (ILS) information unit of invalid size has been received. The
neighbor switch has sent a payload with an invalid size.
Recommended
Action
Investigate the neighbor switch for problems. Run the errShow command on the neighbor switch to
view the error log for additional messages.
Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP
if necessary.
Run the portLogDumpPort command on both the receiving and transmitting ports.