Dell POWEREDGE M1000E - Manual (Page 370)

294 Fabric OS Message Reference
53-1001767-01
FW-1048
42
Severity WARNING
FW-1048
Message
, [FW-1048], ,, INFO, , , is
between high and low boundaries(High=, Low=). Current value
is .
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed from a value
outside of the acceptable range to a value within the acceptable range.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1049
Message
, [FW-1049], ,, INFO, , , value
has changed(High=, Low=). Current value is .
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed.
Recommended
Action
Frequent voltage fluctuations are an indication that the SFP is deteriorating. Replace the SFP.
Severity INFO
FW-1050
Message
, [FW-1050], ,, WARNING, , , is
below low boundary(High=, Low=). Current value is
.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has fallen below the low
boundary.
Recommended
Action
Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0
(Out_of_Range). If continuous or repeated alarms occur, replace the SFP before it deteriorates.
Severity WARNING
FW-1051
Message
, [FW-1051], ,, WARNING, , , is
above high boundary(High=, Low=). Current value is
.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has risen above the high
boundary. High voltages indicate possible hardware failures.