Dell POWEREDGE M1000E - Manual (Page 704)

628 Fabric OS Message Reference
53-1001767-01
SWCH-1019
98
SWCH-1019
Message
, [SWCH-1019], ,, INFO, , Device
name of device> tries to flogi, reject FLOGI as persistent PID is set on device
and port has user area bound to it.
Probable Cause Indicates a WWN-PID and PortAddress binding collision.
Recommended
Action
The Peristent PID is set on the device and requested area cannot be assigned because it is user
bound to a different port. Remove the WWN-PID binding or remove portAddress binding and
re-enable the port and then run the wwnaddress --unbind wwn command or the portaddress
--unbind slot/port command.
Severity INFO
SWCH-1020
Message
, [SWCH-1020], ,, WARNING, ,HA state out
of sync: Standby CP (ver = ) does not support QOS links to
AG(Active CP version = ).
Probable Cause Indicates the standby control processor (CP) does not support links to AG running QOS.
Recommended
Action
Load a firmware version on the standby CP that supports QOS links to AG, using the
firmwareDownload command.
Severity WARNING
SWCH-1021
Message
, [SWCH-1021], ,, WARNING, , HA state
out of sync: Standby CP (ver = ) does not support Dynamic
area on default switch (Active CP version = ).
Probable Cause Indicates the standby control processor (CP) does not support dynamic area on default switch.
Recommended
Action
Load a firmware version on the standby CP that supports dynamic area on default switch, using the
firmwareDownload command.
Severity WARNING