Fw-1435, Fw-1436, Fw-1437 – Dell POWEREDGE M1000E User Manual
Page 420

344
Fabric OS Message Reference
53-1001767-01
FW-1435
42
Recommended
Action
Replace the faulty blade.
Severity
WARNING
FW-1435
Message
change contributing factor Flash: usage out of range.
Probable Cause
Indicates that the switch status is not in a healthy state. This occurred because the flash usage is
out of range. The policy was set using the switchStatusPolicySet command.
Recommended
Action
Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command
Reference for more information about this command.
Severity
WARNING
FW-1436
Message
change contributing factor Marginal ports: numbers> marginal ports. (Ports Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of Recommended Action Replace any faulty or deteriorating small form-factor pluggables (SFPs). Severity WARNING FW-1437 Message change contributing factor faulty ports: Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of Recommended Action Replace any faulty or deteriorating small form-factor pluggables (SFPs). Severity WARNING
marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command.
A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word,
Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is
above the high boundary.
faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port
is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or
port.