Dell POWEREDGE M1000E - Manual (Page 827)

Fabric OS Message Reference 751
53-1001767-01
SULB-1039
128
SULB-1039
Message
AUDIT, , [SULB-1039], INFO, FIRMWARE, CP has completed relocating the
internal firmware image.
Probable Cause Indicates that the firmwareDownload command process has been completed normally on the CP.
Recommended
Action
Run the firmwareShow command to verify the firmware versions.
Severity INFO
SULB-1040
Message
AUDIT, , [SULB-1040], INFO, WARNING, An error has occurred during
relocation of the internal image on the CP.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet
failure.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
Severity WARNING