Dell POWEREDGE M1000E - Manual (Page 359)

Fabric OS Message Reference 283
53-1001767-01
FSS-1008
40
Probable Cause Indicates that the Ethernet connection between the active control processor (CP) and standby CP is
not healthy. The error occurs when the standby CP does not respond to a request from the active
CP within five seconds. This usually indicates a problem with the internal Ethernet connection and
a disruption of the synchronization process.
Recommended
Action
Check the Ethernet connection between the active CP and standby CP (interface eth1) by issuing
net commands such as ifconfig eth1 (as root) or run supportShow/supportSave to validate the
network configuration; then try to restore the synchronization by issuing the haSyncStart
command. If the problem persists, contact your switch service provider.
Severity CRITICAL
FSS-1008
Message
, [FSS-1008], , SLOT cp-slot-number | CHASSIS,
CRITICAL, , FSS Error: .
Probable Cause Indicates that an error has occurred.
Recommended
Action
Run the supportSave command and contact your switch service provider.
Severity CRITICAL
FSS-1009
Message
, [FSS-1009], , SLOT cp-slot-number | CHASSIS, ERROR,
, FSS Error: .
Probable Cause Indicates that an error has occurred.
Recommended
Action
Run the supportSave command and contact your switch service provider.
Severity ERROR
FSS-1010
Message
, [FSS-1010], , SLOT cp-slot-number | CHASSIS,
WARNING, , FSS Warning: .
Probable Cause Indicates that an error might have occurred.
Recommended
Action
No action is required.
Severity WARNING