Fabr-1007, Fabr-1008, Fabr-1009 – Dell POWEREDGE M1000E User Manual
Page 253

Fabric OS Message Reference
177
53-1001767-01
FABR-1007
26
Recommended
Action
In case of severe memory corruption, the system might recover by performing an automatic
failover.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1007
Message
error, caller:
Probable Cause
Indicates that a failure occurred when deallocating an information unit. This message is rare and
usually indicates a problem with the Fabric OS.
Recommended
Action
In case of severe memory corruption, the system might recover by performing an automatic
failover.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1008
Message
description>. Probable Cause Indicates that errors occurred during the request domain ID state; the information unit (IU) cannot • FAB RDI: cannot allocate IU • FAB RDI: cannot send IU Recommended Action No action is required if the message appears with the FABR_1005 message. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Severity WARNING FABR-1009 Message description>. Probable Cause Indicates that errors were reported during the exchange fabric parameter state; cannot allocate
be allocated or sent. If this message occurs with FABR-1005, the problem is usually transitory.
Otherwise, this message is rare and usually indicates a problem with the Fabric OS. The error
descriptions are as follows:
supportSave command and contact your switch service provider.
domain list due to a faulty exchange fabric parameter (EFP) type. This message is rare and usually
indicates a problem with the Fabric OS.