Dell POWEREDGE M1000E - Manual (Page 593)

Fabric OS Message Reference 517
53-1001767-01
SEC-1071
90
Probable Cause Indicates the security database is corrupted for unknown reasons.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1071
Message
, [SEC-1071], ,, ERROR, , No new
security policy data to apply.
Probable Cause Indicates that no changes in the defined security policy database need to be activated at this time.
Recommended
Action
Verify that the security event was planned. First change some policy definitions, then run the
secPolicyActivate command to activate the policies.
Severity ERROR
SEC-1072
Message
, [SEC-1072], ,, ERROR, ,
type> Policy List is Empty!
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1073
Message
, [SEC-1073], ,, ERROR, , No FCS policy
in list!
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1074
Message
, [SEC-1074], ,, ERROR, , Cannot execute
the command on this switch. Please check the secure mode and FCS status.