Sulb-1024, Sulb-1026, Sulb-1030 – Dell POWEREDGE M1000E User Manual
Page 824
748
Fabric OS Message Reference
53-1001767-01
SULB-1024
128
Recommended
Action
The firmwareCommit command will be started automatically after the blade boots up to repair the
secondary partition. If at the end of firmwareCommit, the blade firmware version is still
inconsistent with the active CP firmware, firmwareDownload will automatically be restarted on the
blade. Run the firmwareDownloadStatus command to monitor the progress. If the problem
persists, contact your switch service provider.
Severity
WARNING
SULB-1024
Message
AUDIT,
number>. Probable Cause Indicates the firmwareCommit operation has completed on the specified blade. Recommended Action Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same Severity WARNING SULB-1026 Message AUDIT, number> . Probable Cause Indicates the firmwareCommit command has started on the specified blade. The operation may be Recommended Action Wait for the commit operation to complete. Severity WARNING SULB-1030 Message AUDIT, firmware image. Probable Cause Indicates there may be an error caused by an unexpected disruption of the firmwareDownload
as the active CP firmware, firmwareDownload has completed successfully on the blade. However, if
the firmwareCommit operation has been started to repair the secondary partition, at the end of
firmwareCommit, the blade firmware version may still be inconsistent with the active CP firmware.
In that case, firmwareDownload will automatically be restarted on the blade. Run the
firmwareDownloadStatus command to monitor the progress.
a normal part of firmwareDownload, or it may have started to repair the secondary partition of the
blade if the secondary partition is corrupted.
command, for example, by powering the switch off and on in the middle of a firmwareDownload.
The error may also be caused by persistent storage hardware failure or by a software error.