Dell POWEREDGE M1000E - Manual (Page 108)

32 Fabric OS Message Reference
53-1001767-01
AG-1026
2
AG-1026
Message
, [AG-1026], ,, WARNING, , Unable to
handle the login request on port due to insufficient resources.
Probable Cause Indicates there are insufficient resources.
Recommended
Action
Run configure CLI on AG switch and increase the number of allowed logins on this port.
If the message persists, run the supportFtp (as needed) to set up automatic FTP transfers; then run
the supportSave command and contact your switch service provider.
Severity WARNING
AG-1027
Message
, [AG-1027], ,, WARNING, , Unable to
handle this login request on port because NPIV capability is not enabled on
this port.
Probable Cause Indicates NPIV is not enabled.
Recommended
Action
Run the portcfgnpivport CLI command on the AG switch and enable the NPIV capability on this port.
Severity WARNING
AG-1028
Message
, [AG-1028], ,, WARNING, , Device with
Port WWN tried to perform fabric login through port , without
having access permission.
Probable Cause Indicates the device does not have login access for that port, as per ADS policy set by the user.
Recommended
Action
Add the device in to the ADS allow list for that port using the ag --adsadd command.
Severity WARNING
AG-1029
Message
, [AG-1029], ,, WARNING, , Port Group
has ports going to different fabrics.
Probable Cause Indicates a misconfiguration.
Recommended
Action
Connect all ports in the port group to the same fabric.