beautypg.com

Sec-1135, Sec-1136, Sec-1137 – Dell POWEREDGE M1000E User Manual

Page 608

background image

532

Fabric OS Message Reference

53-1001767-01

SEC-1135

90

SEC-1135

Message

, [SEC-1135], ,, INFO, , Secure fabric

version stamp has been reset.

Probable Cause

Indicates the version stamp of the secure fabric is reset.

Recommended

Action

Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security
policy.

Severity

INFO

SEC-1136

Message

, [SEC-1136], ,, ERROR, , Failed to

verify signature .

Probable Cause

Indicates the receiving switch fails to validate the security database sent from the primary fabric
configuration server (FCS) switch. This message usually indicates that the data package is
corrupted, the time stamp on the package is out of range as a result of a replay attack or
out-of-sync time service, or the signature verification failed. Signature verification failure indicates
either an internal error (such as losing the primary public key) or an invalid database.

Recommended

Action

Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that switch. This message might also be the result of an internal corruption or a hacker attack to
the secure fabric.

Severity

ERROR

SEC-1137

Message

, [SEC-1137], ,, ERROR, , No signature

in

.

Probable Cause

Indicates the receiving switch fails to validate the security database sent from the primary fabric
configurations server (FCS) switch. This message usually indicates that the data package is
corrupted, the time stamp on the package is out of range as a result of a replay attack or
out-of-sync time service, or the signature verification failed. Signature verification failure indicates
either an internal error (such as losing the primary public key) or an invalid database.

Recommended

Action

Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that switch. This message might also be the result of an internal corruption or a hacker attack to
the secure fabric.

Severity

ERROR