Dell POWEREDGE M1000E - Manual (Page 372)

296 Fabric OS Message Reference
53-1001767-01
FW-1115
42
FW-1115
Message
, [FW-1115], ,, INFO, , , is
above high boundary(High=, Low=). Current value is
.
Probable Cause Indicates that the number of times E_Ports have gone down has risen above the high boundary.
E_Ports go down each time you remove a cable or small form-factor pluggable (SFP). SFP failures
also cause E_Ports to go down. E_Port downs might be caused by transient errors.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation. Check both ends of the physical connection and verify that the SFP functions
properly.
Severity INFO
FW-1116
Message
, [FW-1116], ,, INFO, , , is
between high and low boundaries(High=, Low=). Current value
is .
Probable Cause Indicates that the number of times E_Ports have gone down has changed from a value outside of
the acceptable range to a value within the acceptable range. E_Ports go down each time you
remove a cable or small form-factor pluggable (SFP). SFP failures also cause E_Ports to go down.
E_Port downs might be caused by transient errors.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1117
Message
, [FW-1117], ,, INFO, , , value
has changed(High=, Low=). Current value is .
Probable Cause Indicates that the number of fabric reconfigurations has changed. The following actions can cause
a fabric reconfiguration:
• two switches with the same domain ID have connected to one another.
• two fabrics have joined.
• an E_Port has gone offline.
• a principal link has segmented from the fabric.
Recommended
Action
Verify that the cable is properly connected at both ends. Verify that the small form-factor pluggables
(SFPs) have not become faulty. An inexplicable fabric reconfiguration might be a transient error and
might not require troubleshooting.
Severity INFO