Ms-1003, Ms-1004 – Dell POWEREDGE M1000E User Manual
Page 512
436
Fabric OS Message Reference
53-1001767-01
MS-1003
69
•
Run the firmwareDownload command to upgrade the firmware level on the switch to a level
that supports RCS. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater.
•
Wait a few minutes and try the command again.
Severity
INFO
MS-1003
Message
Unstable Fabric(
Probable Cause
Indicates the management server (MS) detected an unstable fabric; the command or operation
might not be successfully completed. This message is often transitory.
The message string can be one of the following:
•
The domain is invalid for a request.
•
Unable to acquire the World Wide Name (WWN) for the corresponding domain.
The domain number is the target domain that caused error.
Recommended
Action
The fabric might be reconfiguring, forming, or merging. Wait for a few minutes and retry the
operation.
Run the fabricShow command or the secFabricShow command to verify that the number of
domains matches the Management Server known domains.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
INFO
MS-1004
Message
1 Domain(d=
).
Probable Cause
Indicates the management server (MS) detected an unstable count of domains in its own local
resource.
Recommended
Action
This message is often transitory.
The fabric might be reconfiguring, forming, or merging. Wait for a few minutes and retry the
operation.
Run the fabricShow command or the secFabricShow command to verify that the number of
domains matches the Management Server known domains.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.