Dell POWEREDGE M1000E - Manual (Page 523)

Fabric OS Message Reference 447
53-1001767-01
Chapter
72
NS System Messages
NS-1001
Message
, [NS-1001], ,, WARNING, , The response
for request 0x from remote switch 0x is larger than
the max frame size the remote switch can support!
Probable Cause Indicates the response payload exceeds the maximum frame size the remote switch can handle.
Recommended
Action
Run the firmwareDownload command to upgrade the remote switch with firmware v4.3 or higher,
or v3.2 or higher, as appropriate for the switch type, so that it can support GMI to handle frame
fragmentation and reassembly.
You can also reduce the number of devices connected to the local switch.
Severity WARNING
NS-1002
Message
, [NS-1002], ,, WARNING, , Remote switch
0x has firmware revision lower than 2.2:
character>
character> which is not supported!
Probable Cause Indicates the local switch cannot interact with the remote switch because of incompatible or
obsolete firmware.
Recommended
Action
Run the firmwareDownload command to upgrade the remote switch to the latest level of firmware.
Severity WARNING
NS-1003
Message
, [NS-1003], ,, INFO, , Number of local
devices , exceeds the standby can support
device count that standby can support>, can't send update.
Probable Cause Indicates the name server on the standby CP has lower supported capability than the active CP
because of different firmware versions running on the active and standby CPs. This means that the
active and standby CPs are out of sync. Any execution of the haFailover or firmwareDownload
commands will be disruptive.
Recommended
Action
To avoid disruption of traffic in the event of an unplanned failover, schedule a firmwareDownload so
that the active and standby CPs have the same firmware version.