Dell POWEREDGE M1000E - Manual (Page 503)

Fabric OS Message Reference 427
53-1001767-01
Chapter
65
LSDB System Messages
LSDB-1001
Message
, [LSDB-1001], ,, ERROR, , Link State ID
out of range
Probable Cause Indicates the specified link state database ID is out of the acceptable range. The valid link state ID
is the same as the valid domain ID, whose range is from 1 through 239. The switch will discard the
record because it is not supported.
Recommended
Action
No action is required.
Severity ERROR
LSDB-1002
Message
, [LSDB-1002], ,, INFO, , Local Link
State Record reached max incarnation#
Probable Cause Indicates the local link state database reached the maximum incarnations.
An "incarnation" is a progressive number that identifies the most recent version of the LSR (link
state record). The switch generates its local link state record when first enabled. The incarnation
number will begin again at 0x80000001 after reaching 0x7FFFFFFF.
Recommended
Action
No action is required.
Severity INFO
LSDB-1003
Message
, [LSDB-1003], , FFDC, CRITICAL, , No
database entry for local Link State Record, domain
Probable Cause Indicates there is no local link state record entry in the link state database. The switch should
always generate its own local entry when starting up.
An "incarnation" is a progressive number that identifies the most recent version of the LSR (link
state record). The switch generates its local link state record when first enabled. By disabling and
enabling the switch, a new local link state record is generated.
Recommended
Action
Run the switchDisable and switchEnable commands. A new local link state record is generated
during the switch enable.