Accton Technology ES4626 - Manual (Page 93)

93
2.5.3.2.2 Commands for Switch Upgrade
2.5.3.2.2.1 copy（FTP）
Command: copy <source-url> [ascii | binary]
Function: Download files to the FTP client.
Parameter ： <source-url> is the location of the source files or directories to be
copied; is the destination address to which the files or directories to be
copied;forms of <source-url> and vary depending on different
locations of the files or directories. ascii indicates the ASCII standard will be
adopted;binary indicates that the binary system will be adopted in the file transmission
（ default transmission method）.When URL represents an FTP address, its form should
be:
ftp://:@{<ipaddress>|<ipv6address>| }/,a
mongst is the FTP user name, is the FTP user
password,<ipaddress>|<ipv6address> is the IPv4 or IPv6 address of the FTP
server/client, is the name of the host mapping with the IPv6 address,it does
not support the file download and upload with hosts mapping with IPv4
addresses, is the name of the FTP upload/download file.
Special keywords of the filename
Keywords Source or destination addresses
running-config Running configuration files
startup-config Startup configuration files
nos.img System files
nos.rom System startup files
Command Mode: Admin Mode
Usage Guide:
This command supports command line hints,namely if the user can enter
commands in following forms: copy ftp:// or copy ftp:// and
press Enter,following hints will be provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >
ftp username>
ftp password>
ftp filename>
Requesting for FTP server address, user name, password and file name
Examples:
（ 1）Save images in the FLASH to the FTP server of 2004:1:2:3::6
Switch#copy nos.img ftp://username:password@2004:1:2:3::6/ nos.img
（ 2）Obtain system file nos.img from the FTP server 2004:1:2:3::6