Accton Technology ES4626 - Manual (Page 426)

426
(4) Delete the specified route in RIPng route table
Command Explanation
Admin Mode
clear IPv6 rip route
{|kernel|static|con
nected|rip|ospf|isis|bgp|all}
the command deletes a specified route from
the RIP route table
13.5.3 Commands For RIPng
13.5.3.1 aggregate-address
Command: [no] aggregate-address<ipv6-address>
Function: Aggregate RIPng route. The “[no]
aggregate-address<ipv6-address> “ command cancels the aggregation
Parameter: <ipv6-address> is the IPv6 network address, shown in cloned hex notation
with the length of prefix.
Default: No aggregation to any address
Command Mode: Router mode
Example:
Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# aggregate-address 3ffe:8088::/32
13.5.3.2 clear ipv6 route
Command: clear ipv6 rip route { | kernel |static | connected |rip
|ospf |isis | bgp |all }
Function:
Clear specific route from the RIPng route table
Parameter: Clears the route exactly match with the destination address from the RIP
route table
is the destination address shown in hex notation with prefix length.
kernel delete kernel route from the RIPng route table
static delete static route from the RIPng route table
connected delete direct route from the RIPng route table
rip delete RIPng route from the RIPng route table only
ospf delete IPv6 OSPF route from the RIPng route table only
bgp delete IPv6 BGP route from the RIPng route table only
ISIS delete ivp6 isis route from the RIPng route table only
all delete all routes from the RIPng route table