Accton Technology ES4626 - Manual (Page 631)

631
Switch (config)#show ip pim neighbor
16.3.3.12 ip pim register-rate-limit
Command: ip pim register-rate-limit <limit>
no ip pim register-rate-limit
Function: This command is used to configure the speedrate of DR sending register
packets; the unit is packet/second. The “no ip pim Register-rate-limit” command
restores the default value. This configured speedrate is each（S, G）state’s ,not the whole
system’s.
Parameter: ranges from 1 to 65535.
Default: No limit for sending speed
Command Mode: Global Mode
Usage Guide: This configuration is to prevent the attack to DR, limiting sending
REGISTER packets.
Example: Configure the speedrate of DR sending register packets to 59 p/s.
Switch (config)#ip pim register-rate-limit 59
16.3.3.13 ip pim register-rp-reachability
Command: ip pim register-rp-reachability
no ip pim register-rp-reachability
Function: This command makes DR check the RP reachability in the process of
registration.
Parameter:
None
Default: Do not check
Command Mode: Global Mode
Usage Guide: This command configures DR whether or not to check the RP reachability.
Example: Configure DR to check the RP reachability.
Switch (config)#ip pim register-rp-reachability
Switch (config)#
16.3.3.14 ip pim register-source
Command: ip pim register-source {<A.B.C.D> | <ifname> | <ethernet> | vlan
<vlan-id>}
no ip pim register-source
Function: This command is to configure the source address of register packets sent by
DR to overwrite default source address. This default source address is usually the RPF
neighbor of source host direction.
Parameter: <ifname> is the interface name,