Accton Technology ES4626 - Manual (Page 67)

67
Switch(Config-Ethernet0)#exit
Switch(Config)#logging 3ffe:506::4 facility local7 level warnings
2.3 Configurate Switch IP Addresses
All Ethernet ports of ES4624-SFP/ES4626-SFP switch is default to Data Link layer
ports and perform layer 2 forwarding. VLAN interface represent a Layer 3 interface
function which can be assigned an IP address, which is also the IP address of the switch.
All VLAN interface related configuration commands can be configured under VLAN Mode.
ES4624-SFP/ES4626-SFP switch provides three IP address configuration methods:
& Manual
& BootP
& DHCP
Manual configuration of IP address is assign an IP address manually for the switch.
In BootP/DHCP mode, the switch operates as a BootP/DHCP client, send broadcast
packets of BootPRequest to the BootP/DHCP servers, and the BootP/DHCP servers
assign the address on receiving the request. In addition, ES4624-SFP/ES4626-SFP
switch can act as a DHCP server, and dynamically assign network parameters such as IP
addresses, gateway addresses and DNS server addresses to DHCP clients DHCP
Server configuration is detailed in later chapters.
2.3.1 Switch IP Addresses Configuration Task List
1. Manual configuration
2. BootP configuration
3. DHCP configuration
1. Manual configuration
Command Explanation
ip address
[secondary]
no ip address
[secondary]
Configure the VLAN interface IP address;
the “no ip address
[secondary]” command deletes VLAN
interface IP address.
2. BootP configuration
Command Explanation
ip address bootp
no ip address bootp
Enable the switch to be a BootP client and
obtain IP address and gateway address
through BootP negotiation; the no ip