2 debug gvrp, 3 bridge-ext garp timer hold, 4 bridge-ext garp timer join – Accton Technology ES4626 User Manual
Page 178
178
5.2.3.2 debug gvrp
Command: debug gvrp
no debug gvrp
Function:
Enable the GVRP debugging function: the “ no debug gvrp” command
disables the function.
Command mode:
Admin Mode
Default:
GVRP debug information is disabled by default.
Usage Guide:
Use this command to enable GVRP debugging, GVRP packet processing
information can be displayed.
Example:
Enable GVRP debugging.
Switch#debug gvrp
5.2.3.3 bridge-ext garp timer hold
Command:bridge-ext garp timer hold <timer-value>
no bridge-ext garp timer hold
Function:
Set the hold timer for GARP; the “ no garp timer hold” command restores the
default timer setting.
Parameter:
is the value for GARP hold timer, the valid range is 100 to
327650 ms.
Command mode:
Interface Mode
Default:
The default value for hold timer is 100 ms.
Usage Guide:
When GARP application entities receive a join message, join message will
not be sent immediately. Instead, hold timer is started. After hold timer timeout, all join
messages received with the hold time will be sent in one GVRP frame, thus effectively
reducing protocol message traffic.
Example: Set the GARP hold timer value of port 1/10 to 500 ms.
Switch(Config-Ethernet1/10)#bridge-ext garp timer hold 500
5.2.3.4 bridge-ext garp timer join
Command: bridge-ext garp timer join <timer-value>
no bridge-ext garp timer join
Function:
Set the join timer for GARP; the “no bridge-ext garp timer join” command
restores the default timer setting.
Parameter:
is the value for join timer, the valid range is 100 to 327650 ms.
Command mode:
Interface Mode
Default:
The default value for join timer is 200 ms.
Usage Guide:
GARP application entity sends a join message after join timer over, other
GARP application entities received the join message will register this message.